Table 439 ntrb21 switch settings – Nortel Networks Circuit Card 311 User Manual
Page 1075
Architecture
1075
The transmitter takes the binary data (dual unipolar) from the PCM
transceiver and produces bipolar pulses for transmission to the external
digital facility. The Digital Signal – Level 1 (DS-1) transmit equalizer enables
the cabling distance to be extended from the card to the Digital Signal
Cross-connect – Level 1 (DSX-1), or LD-1. Equalizers are switch selectable
through dip-switches. The settings are shown in
Table 439
NTRB21 switch settings
Switch Setting
Distance to Digital
Cross-Connect
1
DCH F/W
2
(LEN 0)
3
(LEN 1)
4
(LEN 2)
0 - 133 feet
Off
Off
Off
On
133 - 266 feet
Off
On
On
Off
266 - 399 feet
Off
Off
On
Off
399 - 533 feet
Off
On
Off
Off
533 - 655 feet
Off
Off
Off
Off
Receiver
The receiver extracts data and clock from an incoming data stream and
outputs clock and synchronized data. At worst case DSX-1 signal levels, the
line receiver operates correctly with up to 655 feet of ABAM cable between
the card and the external DS-1 signal source.
The receiver extracts data and clock from an incoming data stream and
outputs clock and synchronized data. At worst case DSX-1 signal levels, the
line receiver operates correctly with up to 655 feet of ABAM cable between
the card and the external DS1 signal source.
The receiver extracts data and clock from an incoming data stream and
outputs clock and synchronized data. At worst case DSX-1 signal levels, the
line receiver operates correctly with up to 655 feet of ABAM cable between
the card and the external DS-1 signal source.
Connector pinout
The connection to the external digital carrier is through a 15 position Male
D-type connector.
Table 440
DS-1 line interface pinout for NTBK04 cable
From 50-pin
MDF connector
To DB-15
Signal name
Description
pin 48
pin 1
T
transmit tip to network
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.