Nortel Networks Circuit Card 311 - Manual (Page 234)

234 NT5D11 and NT5D14 Lineside T1 Interface cards
Notation Used:
CAPS - Required Letters [ ] - Optional | - Either/Or
Each of these commands can be executed by typing the first letter of the
command or by typing the entire command. Command sets are entered
by typing the first letter of the first command, a space, and the first letter
of the second command or by typing the entire command.
Table 104 "MMI
commands and command sets" (page 234) shows all the possible command
sets, listed in alphabetical order. These commands are described by subject
later in this section.
Table 104
MMI commands and command sets
Command Description
A D Alarm Disable
Disables all alarms
A E Alarm Enable
Enables all alarms
C A Clear Alarm
Clears all alarms, terminates line processing, and resets the T1 bit error rate and
frame slip counters
C A L Clear Alarm Log
Clears the alarm log
C E Clear Error
Clears the error counter for the T1
D A [P] Display Alarms [Pause]
Displays the alarm log – a list of the most recent 100 alarms along with time and
date stamps
D C Display Configuration
Displays the configuration settings for the cards including:
• the serial number of the card
• MMI firmware version
• date and time
• alarm enable/disable setting
• self-clearing enable/disable setting
• settings entered in Set Configuration
• dip switch settings
D H [P] Display History [Pause]
Displays performance counters for the past 24 hours.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.