Nortel Networks Circuit Card 311 - Manual (Page 74)

74 Acceptance tests
—End—
Digitone receiver cards
Note: The DTR daughterboard connected to a QPC659 Dual Loop
Peripheral Buffer card cannot be assigned when the IPE shelf is used
in single loop mode.
Procedure 4
Testing digitone receiver cards
Step Action
Use this procedure to test a Digitone receiver (DTR) card, a DTR
daughterboard, or the DTR function on the NT8D18 Network/DTR card.
1 Log into the system:
LOGI (password)
2 See if the Digitone receiver to be tested is disabled: LD 34
STAT
The system responds with the terminal number (TN), or numbers, of
any disabled Digitone receivers.
3 If the Digitone receiver is disabled, enable it:
ENLR l s c u loop, shelf, card, and unit numbers
4 Test the Digitone receiver:
DTR l s c u loop, shelf, card, and unit numbers
If the system response is other than OK, seeSoftware Input/Output
Reference — Administration (NN43001-611) to analyze the
messages.
5 End the session in LD 34:
****
—End—
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.