Applications – Nortel Networks Circuit Card 311 User Manual
Page 828
828
NT8D41BA Quad Serial Data Interface Paddle Board
Port 1 — SW 3
Port 1 — SW 2
Mode
1
2
3
4
5
6
1
2
3
4
5
6
NT1P61 (Fiber)
on
on
on
on
on
off
on
on
on
off
on
off
Port 4 — SW 9
Port 4 — SW 8
DTE (terminal)
on
on
on
off
on
off
off
on
off
on
off
on
DCE (modem)
off
off
off
on
off
on
on
off
on
off
on
off
NT1P61 (Fiber)
on
on
on
on
on
off
on
on
on
off
on
off
Software service changes
Once the NT8D841BA QSDI paddle board has been installed in the
system, the system software needs to be configured to recognize it, using
the Configuration Record program LD 17. Instructions for running this
program are found in Software Input/Output Reference — Administration
(NN43001-611).
Some of the prompts that are commonly used when running the
Configuration Record program LD 17 are shown in
Prompts to configure the NT8D841Ba paddle board." (page 828)
These
parameters must be set for each port if both ports are being used.
Table 325
LD 17 - Prompts to configure the NT8D841Ba paddle board.
Prompt
Response
Description
REQ:
CHG
Change configuration
TYPE:
ADAN
Configuration type
ADAN
NEW TTY x
NEW PRT x
Define a new system terminal (printer) port as device x, where x
= 0 to 15.
CTYPE
SDI4
Quad port card
DES
XQSDI
Quad density QSDI paddle board.
USER
xxx
Enter the user of port x. The values that can be entered depend
on the software being used. See the Software Input/Output
Reference — Administration (NN43001-611) for details.
XSM
(NO) YES
Port is used for the system monitor.
Applications
The NT8D41BA Quad Serial Data Interface paddle board is used to connect
the switch to a variety of communication devices, printers, and peripherals.
Any RS-232-C compatible device can be connected to either of the card’s
two serial ports.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.