Table 393 carrier shield grounding switch settings, Table 394 carrier shield grounding switch settings, Table 395 carrier shield grounding switch settings – Nortel Networks Circuit Card 311 User Manual

Page 940

Advertising
background image

940

NTAK79 2.0 Mb PRI card

Table 393
Carrier shield grounding switch settings

Switch

Carrier Pair

On

Off

S4-1

Rx shield

Open

GND

S4-2

Tx shield

Open

GND

NTAK79 provides for the capability of selectively grounding the shield of
the Tx and/or Rx pairs of the carrier. Closing (down) the on-board switch
applies FGND to the appropriate carrier cable shield. The switch settings
are shown below.

Table 394
Carrier shield grounding switch settings

Switch

Carrier Pair

On

Off

S4-1

Rx shield

Open

GND

S4-2

Tx shield

Open

GND

The NTAK79 card provides the capability of selectively grounding the shield
of the Tx and/or Rx pairs of the carrier. Closing (down) the on-board switch
applies FGND to the appropriate carrier cable shield. The switch settings are
shown in

Table 395 "Carrier shield grounding switch settings" (page 940)

.

Table 395
Carrier shield grounding switch settings

Switch

Carrier Pair

On

Off

S4-1

Rx shield

Open

GND

S4-2

Tx shield

Open

GND

Receiver functions

The receiver extracts data and clock from an AMI (Alternate Mark Inversion)
coded signal and outputs clock and synchronized data. The receiver is
sensitive to signals over the entire range of cable lengths and requires
no equalization. The clock and data recovery meets or exceeds the
jitter specifications of the CCITT recommendation G.823, and the jitter
attenuation requirements of the CCITT recommendation G.742. This
provides jitter attenuation increasing from 0 dB to 60 dB over the frequency
range from about 6 Hz to 6 KHz.

The receiver extracts data and clock from an AMI (Alternate Mark Inversion)
coded signal and outputs clock and synchronized data. The receiver is
sensitive to signals over the entire range of cable lengths and requires
no equalization. The clock and data recovery meets or exceeds the
jitter specifications of the CCITT recommendation G.823 and the jitter

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

01.04

Standard

Release 5.0

23 May 2008

Copyright © 2003-2008, Nortel Networks

.

Advertising