Nortel Networks Circuit Card 311 - Manual (Page 456)

456 NT7D16 Data Access card
When the user enters the autobaud character, <CR>, and the dialing mode
is Manual (not Hotline), the DAC sends the following menu:
<CR><LF><CR><LF><LF>ENTER NUMBER OR H (FOR HELP):<SP>
If the user enters <CR>, the DAC presents this prompt again. When a
number is entered, the DAC attempts to place the call. Entering H at this
point lists the Primary Commands menu:
Primary Commands Menu:
A - Auto Dial C - Call
D - Display M - Modify
S - Speed Call
CTRL Z (Abort Keyboard Dialing)
Select: <SP>
Whenever a Primary command is expected, the user may enter the Parity
command (period). If Auto Parity has already been done, the Invalid
Command menu is presented:
Invalid Command/Entry
Re-Enter: <SP>
The user’s port is set to idle by entering CTRL Z. Any call in progress
is dropped and any Ring Again placed is released. Once the Primary
Command menu appears, the user must enter C to place a call. The DAC
does not accept a number in place of a Primary command.
Primary commands
Once the Primary menu has appeared, only primary commands are
accepted.
Call (C)
The Call command must be used to place a call once the Primary menu
appears. The DAC does not accept only number.
C<CR>
ENTER NUMBER:<SP>
xxxxxxx<CR>
CALLING xxxxxxx
RINGING
ANSWERED
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.