Nortel Networks Circuit Card 311 - Manual (Page 1086)

1086 NTVQ55AA ITG Pentium card
WARNING
The NWK connector looks like a 9-pin serial connector. Do not
connect a serial cable or any other cable to it. If a cable is installed
to the NWK connector, the TLAN interface card is disabled.
ITG-P LED (Card Status)
The red status faceplate LED indicates the enabled/disabled status of the
24-card ports. The LED is on (red) during the power-up or reset sequence.
The LED remains lit until the card is enabled. If the LED remains on, this
indicates the self-test failed, the card is disabled, or the card rebooted.
Reset switch
Press the Reset switch to reset the card without having to cycle power to
the card. This switch is normally used after a software upgrade to the card,
or to clear a fault condition.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.