Table 353 ntak09 led states during self-test – Nortel Networks Circuit Card 311 User Manual
Page 864
864
NTAK09 1.5 Mb DTI/PRI card
LED
State
Definition
On (Green)
The NTAK09 circuit card is in an active state. No alarm states exist,
the card is not disabled, and it is not in a loopback state.
ACT
Off
An alarm state or loopback state exists, or the card has been
disabled. See the other LEDs for more information.
On (Red)
A red-alarm state has been detected.
RED
Off
No red alarm.
On (Yellow)
A yellow alarm state has been detected.
YEL
Off
No yellow alarm.
On (Green)
NTAK09 is in loop-back mode.
LBK
Off
NTAK09 is not in loop-back mode.
NTAK09 DTI/PRI power on self-test
When power is applied to the NTAK09 DTI/PRI circuit card, the card
performs a self-test. The LEDs directly associated with the NTAK09 circuit
card are DIS, ACT, RED, YEL, and LBK. The clock controller LED is also
included in the power on self-test.
Table 353 "NTAK09 LED states during
provides the state of the NTAK09 LEDs during the
self-test procedure.
Table 353
NTAK09 LED states during self-test
Action
LED State
Power up system
Top five LEDs light for eleven seconds.
Self-test in progress
Top five LEDs go out for one second.
If the self-test passes, the top five LEDs flash
on and off three times.
If the self-test detects a partial failure, the top
five LEDs flash on and off five times.
When the self-test is completed, the LEDs are
set to their appropriate states.
When power is applied to the NTAK09 DTI/PRI circuit card, the card
performs a self-test. The LEDs directly associated with the NTAK09 circuit
card are DIS, ACT, RED, YEL, and LBK. The clock controller LED is also
included in the power on self-test.
Table 354 "NTAK09 LED states during
provides the state of the NTAK09 LEDs during the
self-test procedure.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.