Nortel Networks Circuit Card 311 User Manual

Page 184

Advertising
background image

184

NT5D11 and NT5D14 Lineside T1 Interface cards

— programming of loop interface control circuits for administration of

channel operation

— maintenance diagnostics

interface with the line card circuit:

— converts on/off-hook, and ringer control messages from the DS-30X

loop into A/B bit manipulations for each time slot in the T1 data
stream, using robbed bit signaling.

the front panel LED when the card is enabled or disabled by instructions
from the NT8D01 controller card.

Card LAN interface

Maintenance data is exchanged with the CPU over a dedicated
asynchronous serial network called the Card LAN link.

Maintenance data is exchanged with the Common Equipment CPU over a
dedicated asynchronous serial network called the Card LAN link. The Card
LAN link is described in

"Card LAN link" (page 25)

.

Maintenance data is exchanged with the CPU over a dedicated
asynchronous serial network called the Card LAN link.

Sanity timer

The Lineside T1 card also contains a sanity timer that resets the
microcontroller in the event of a loss of program control. The microcontroller
must service the sanity timer every 1.2 seconds. If the timer is not properly
serviced, it times out and causes the microcontroller to be hardware reset.

The Lineside T1 card also contains a sanity timer that resets the
microcontroller in the event of a loss of program control. If the timer is
not properly serviced by the microcontroller, it times out and causes the
microcontroller to be hardware reset. If the microcontroller loses control and
fails to service the sanity timer at least once per second, the sanity timer
automatically resets the microcontroller, restoring program control.

The Lineside T1 card also contains a sanity timer that resets the
microcontroller in the event of a loss of program control. The microcontroller
must service the sanity timer every 1.2 seconds. If the timer is not properly
serviced, it times out and causes the microcontroller to be hardware reset.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

01.04

Standard

Release 5.0

23 May 2008

Copyright © 2003-2008, Nortel Networks

.

Advertising