Nortel Networks Circuit Card 311 - Manual (Page 460)

460 NT7D16 Data Access card
DCD Control: DynamicDCD Control: Forced On
By entering L on the keyboard, you enter the Long Break Detect Modify
menu. Respond to the following prompts to enable or disable the detection
of the Long Break as an abandon signal.
L <CR>
Long Break:Detected
Ignored
Detect Long Break? (Y/N): <SP>
Y <CR> N <CR>
Long Break: Detected Long Break: Ignored
To exit the Modify menu, enter Q. This entry returns you to the Primary
commands menu. To view the port’s parameters, enter D when in the
Primary Commands menu. This display shows the Display Options menu.
Display Options Menu:
A - Auto Dial number D - Date and Time
K - Feature Keys P - Data Port Parameters
Q - Quit Display S - Speed Call number(s)
CTRL Z (Abort Keyboard Dialing)
Select: <SP>
Ring Again
When a call is placed to a busy DN, the DAC prompts you to activate
Ring Again. The Ring Again feature alerts you as soon as the dialed DN
becomes free. Primary Commands menu is displayed when the Ring Again
is activated. The following is the prompt and response sequence enabling
the Ring Again feature.
Note: If you hang up the call, or give an abandon command, Ring
Again is canceled.
BUSY, RING AGAIN? (Y/N): <SP>
Y <CR> or N <CR>
RING AGAIN PLACED
Primary Commands Menu:
A - Auto Dial C - Call
D - Display M - Modify
S - Speed Call
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.