Nortel Networks Circuit Card 311 - Manual (Page 461)

Keyboard dialing 461
CTRL Z (Abort Keyboard Dialing)
Select: <SP>
If a Ring Again request has already been placed, the DAC offers the option
of overriding the previous request.
RING AGAIN ACTIVE, REPLACE? (Y/N): <SP>
Y <CR>
RING AGAIN PLACED
Primary Commands Menu:
A - Auto Dial C - Call
D - Display M - Modify
S - Speed Call
CTRL Z (Abort Keyboard Dialing)
Select: <SP>
When the called DN becomes available, the system notifies the DAC, which
then prompts the user to place the call. If you do not respond to the Ring
Again prompt within a software determined time period, Ring Again is
canceled, and the Primary Commands Menu appears.
DATA STATION NOW AVAILABLE, PLACE CALL? (Y/N/<Y>): <SP>
Y <CR>
CALLING XXXX
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS
Note 1: If the Ring Again notice occurs during a parameter change, the
prompt only appears after the change has been completed.
Note 2: If the notice occurs during an active call, the Ring Again notice
is ignored. When the active call is completed, you are notified that the
Ring Again call was canceled.
You can also cancel the Ring Again request at this time.
DATA STATION NOW AVAILABLE, PLACE CALL? (Y/N/[Y]): <SP>
N <CR>
RING AGAIN CANCELLED
Primary Commands Menu:
A - Auto Dial S - Speed Call
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.