Nortel Networks Circuit Card 311 User Manual
Page 183
Functional description
183
The Lineside T1 card contains two microcontrollers that control the internal
operation of the card and the serial card LAN link to the controller card. The
microcontrollers control the following:
•
reporting to the CE CPU through the card LAN link:
— card identification (card type, vintage, serial number)
— firmware version
— self-test results
— programmed unit parameter status
•
receipt and implementation of card configuration:
— control of the T1 line interfaces
— enabling/disabling of individual units or entire card
— programming of loop interface control circuits for administration of
channel operation
— maintenance diagnostics
•
interface with the line card circuit:
— converts on/off-hook, and ringer control messages from the DS-30X
loop into A/B bit manipulations for each time slot in the T1 data
stream, using robbed bit signaling.
•
the front panel LED when the card is enabled or disabled by instructions
from the NT8D01 controller card.
Microcontroller
The Lineside T1 card contains a microcontroller that controls the internal
operation of the card and the serial card LAN link to the controller card. The
microcontroller controls the following:
•
reporting to the CPU via the card LAN link:
— card identification (card type, vintage, serial number)
— firmware version
— self-test results
— programmed unit parameter status
•
receipt and implementation of card configuration:
— control of the T1 line interface
— enabling/disabling of individual units or entire card
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.