Table 396 settings for the dchi dip switch (sw1), Table 397 settings for the dchi dip switch (sw1) – Nortel Networks Circuit Card 311 User Manual

Page 943

Advertising
background image

Architecture

943

The NTAK79 has an onboard D-Channel Handler Interface (DCHI). It is the
equivalent to a single port of an NTAK02 SDI/DCH pack. This enables for
a completely operational ISDN PRA link with clock synchronization and
D-channel on a single circuit card.

The onboard D-channel has one status LED on the NTAK79 faceplate to
indicate enabled/disabled states. See

Table 376 "NTAK79 LEDs" (page

924)

.

The on-board DCHI can be operated in two separate modes as defined by
an on-board dip switch. It can operate in a standard DCHI mode common
to most ISDN standard countries. The U.K. specific mode that uses the
DPNSS format is not supported at this time.

Table 396
Settings for the DCHI dip switch (SW1)

Switch

Function

On

Off

S1-1

En/Dis

Enabled

Disabled

S1-2

F/W Mode

DPNSS (not

supported at

this time)

DCHI

The D-channel support interface is a 64 kbps, full-duplex serial bit stream
configured as a DCE device. The data signals include: (1) Receive data
output, (2) transmit data input, (3) receive clock output, and (4) transmit clock
output. The receive and transmit clocks can be of slightly different bit rates
from each other as determined by the transmit and receive carrier clocks.

The NTAK79 has an onboard D-channel handler interface (DCHI). It is the
equivalent to a single port of an NTAK02 SDI/DCH pack. This allows for
a completely operational ISDN PRA link with clock synchronization and
D-channel on a single circuit card.

The onboard D-channel has one status LED on the NTAK79 faceplate to
indicate enabled/disabled states. (See

Table 377 "NTAK79 LEDs" (page

926)

).

The on-board DCHI can be operated in two separate modes as defined by
an on-board dip switch. It can operate in a standard DCHI mode common
to most ISDN standard countries. It can also operate in an U.K. specific
mode using the DPNSS format.

Table 397
Settings for the DCHI dip switch (SW1)

Switch

Function

On

Off

S1-1

En/Dis

Enabled

Disabled

S1-2

F/W Mode

DPNSS

DCHI

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

01.04

Standard

Release 5.0

23 May 2008

Copyright © 2003-2008, Nortel Networks

.

Advertising