Nortel Networks Circuit Card 311 - Manual (Page 201)

Installation and configuration 201
Vintage levels cabling 16 ports For modules with vintage levels that
cabled 16 ports to the I/O panel, the Lineside T1 card can be installed into
the following card slot pairs:
Available: Motherboard/Daughterboard
0 and 1
1 and 2
4 and 5
7 and 8
8 and 9
9 and 10
12 and 13
13 and 14
The Lineside T1 card cannot be installed into the following card slot pairs:
Restricted: Motherboard/Daughterboard
2 and 3
3 and 4
6 and 7
10 and 11
11 and 12
14 and 15
If the Lineside T1 card must be installed into one of the restricted card slot
pairs, rewire the IPE module card slot to the I/O panel by installing an
additional NT8D81 cable from the Lineside T1 card motherboard slot to
the I/O panel. Re-arrange the three backplane connectors for the affected
card slots. This permits the connection of the NT5D13AA Lineside T1 card
carrier and maintenance external I/O cable at the IPE module I/O panel
connector for card slots that are otherwise restricted.
Also, all Lineside T1 card connections can be made at the main distribution
frame instead of connecting the NT5D13 Lineside T1 card external I/O cable
at the I/O panel. This eliminates these card slots restrictions.
For modules with vintage levels that cabled 16 ports to the I/O panel, the
Lineside T1 card can be installed into the following card slot pairs:
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.