Table 403 ntbk50 faceplate leds – Nortel Networks Circuit Card 311 User Manual

Page 970

Advertising
background image

970

NTBK50 2.0 Mb PRI card

LED

State

Definition

RED

On (Red)

A red alarm state has been detected. This represents a local alarm
state of Loss of Carrier (LOS), Loss of Frame (LFAS), or Loss of
CRC Multiframe (LMAS).

Off

No red (local) alarm.

YEL

On (Yellow)

A yellow alarm state has been detected. This represents a remote
alarm indication from the far end. The alarm may be either Alarm
Indication (AIS) or Remote Alarm (RAI).

Off

No yellow (remote) alarm.

LBK

On (Green)

2.0 Mb PRI is in loop-back mode.

Off

2.0 Mb PRI is not in loop-back mode.

CC

On (Red)

The clock controller is software disabled.

On (Green)

The clock controller is enabled and is either locked to a reference or
is in free run mode.

Flashing
(Green)

NTAK20 is equipped and is attempting to lock (tracking mode) to a
reference. If the LED flashes continuously over an extended period
of time, check the CC STAT in LD 60. If the CC is tracking this can
be an acceptable state. Check for slips and related clock controller
error conditions. If none exist, then this state is acceptable, and the
flashing is identifying jitter on the reference.

Off

The clock controller is not equipped.

DCH

On (Red)

DCH is disabled.

On (Green)

DCH is enabled, but not necessarily established.

Off

DCH is not equipped.

The NTBK50 uses a standard IPE-sized (9.5" by 12.5"), multilayer printed
circuit board. The faceplate is 7/8" wide and contains seven LEDs.

In general, the LEDs operate as shown in

Table 403 "NTBK50 faceplate

LEDs" (page 970)

.

Table 403
NTBK50 faceplate LEDs

LED

State

Definition

OOS

On (Red)

The NTBK50 2.0 Mb PRI circuit card is either disabled or
out-of-service. Also, the state of the card after power-up, completion
of self test, and exiting remote loopback.

Off

The NTBK50 2.0 Mb PRI is not in a disabled state.

ACT

On (Green)

The NTBK50 2.0 Mb PRI circuit card is in an active state.

Off

The NTBK50 2.0 Mb PRI is in a disabled state. The OOS LED is red.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311

01.04

Standard

Release 5.0

23 May 2008

Copyright © 2003-2008, Nortel Networks

.

Advertising