Hach-Lange TITRALAB 860_865 Reference Manual - Manual (Page 133)

Titra Lab ® TitraLab 860 and 865 Reference Manual
Page 133
Method A method, groups the parameters necessary to perform a sample
analysis. The following groups of parameters exist:
Edit method parameters
Sample parameters
Result parameters
Printout parameters
QC parameters
An electrode calibration method is defined and saved with the elec-
trode. Call the method up using the electrode name.
A reagent calibration method is defined and saved with the reagent.
Call the method up using the reagent name.
The method modes available on a TIM860 or TIM865 are:
• Measurement,
• End point,
• Monotonic IP,
• Dynamic IP,
• Continuous IP,
• Coupled,
• Addition (TIM865 or TIM860 with an ABU52).
The electrode and reagent installed in the working system
must also be defined as part of the method. Go to Method
parameters menu and define the electrode and reagent used.
Refer to "Programming method", page 158 .
Method ID Name of the method.
Enter in:
Edit method menu.
Refer to "Edit method menu", page 95 .
Range available:
Up to 16 alphanumeric characters.