Hach-Lange TITRALAB 860_865 Reference Manual - Manual (Page 178)

Titra Lab ® TitraLab 860 and 865 Reference Manual
Page 178
Replace reagent The procedure described below installs the reagents used by the cur-
rent sequence or method. If a reagent with an ID different to the one
used by the method, is installed at the address indicated, the Titration
Manager detects the error and prompts you for the replacement. Dur-
ing replacement, a new batch number and expiry date are entered. A
reagent replacement can be performed with or without rinsing the
burette.
Replace the reagent as follows:
1. Select the method or the sequence which uses the new reagent.
2. In the Reagents window, press 2 then 1.
3. Check the new reagent's identification data.
4. Enter the batch number and expiry date of the new reagent.
5. Press 1 to confirm.
6. Press 1 to rinse the burette. Press 2 to continue with no rinse.
7. The burette is emptied. A rinse is performed (if requested). The
burette is filled with air then emptied.
8. Install the new reagent bottle, press
✓.
9. The instrument runs the Flush procedure using the new reagent,
then fills the burette. The replacement is complete.
Replacing
reagent bottle The bottle exchange procedure allows you to replace the reagent bot-
tle with another reagent of same ID. During the procedure, a new
batch number and expiry date are entered. A bottle exchange is per-
formed without rinsing the burette.
Replace the reagent bottle as follows:
1. Select the method or the sequence which uses the reagent that
requires replacing.
2. From the Reagents window, press 2 Install reagents then 2 Bottle
exchange.
3. Select the reagent ID from the list.
4. Press 1 to confirm.
5. As for a reagent installation, enter the batch number and expiry
date given on the reagent bottle. Press 1 to confirm.
6. Follow the instructions displayed. At the end the burette is filled
with the new reagent.