Hach-Lange TITRALAB 860_865 Reference Manual - Manual (Page 189)

Titra Lab ® TitraLab 860 and 865 Reference Manual
Page 189
Rinse burette For safe reagent handling rinse the burette each time the burette is to
be replaced. It makes sure the delivery tubes and tubings are reagent
free. The rinse cycle lasts for approximately 5 minutes.
To rinse a burette:
1. Enter Burette functions menu:
1. Select the burette in the Address field, see "Address", page 51 .
2. Press 4 Rinse.
The rinse procedure runs as follows:
• Empties the burette.
• Prompts you to remove the reagent bottle from the specified
address.
• Fills the burette with air, then empties.
• Prompts you to install the rinse bottle.
• Runs the rinse programme using the rinse solution.
• Prompts you to remove the rinse bottle.
• Fills the burette with air, empties, then refills.
Rinse time When a Sample Changer is in use enter the time (in minutes and
seconds) the electrodes should be immersed in each static rinse
beaker.
Refer to "Number of static rinses", page 146 .
Enter in:
Setup menu > Configuration (if Sample changer = SAC80,
SAC90, SAC850 or SAC950)
Range available:
00:00 to 30:59 min:s