Hach-Lange TITRALAB 860_865 Reference Manual - Manual (Page 198)

Titra Lab ® TitraLab 860 and 865 Reference Manual
Page 198
Sample changer To automate your entire titration procedure (up to 126 samples in one
go), the SAC80, SAC90, SAC850 or SAC950 sample changers can
be connected to the SAC socket of the Titration Manager using the
cable, part no. A95A202 (SAC80/SAC90) or A95X501 (SAC850/
SAC950).
Refer to "Sample changer cable - A95A202 (SAC80/SAC90)", page
199
.
Refer to "Sample changer cable - A95X501 (SAC850/SAC950)", page
199
.
When using a sample changer, you have to indicate to the Titration
Manager which model is used.
Enter in:
Setup menu > Configuration
Range available:
SAC80, SAC90, SAC850, SAC950, No
Depending on the sample changer used, you have to enter other
configuration parameters:
• For a SAC80 or SAC90:
Number of rinses,
see "Number of static rinses", page 146 ,
Duration of a rinse, see "Rinse time", page 189 .
• For a SAC850 or SAC950:
Automatic detection of beakers,
see "Beaker detection", page 65 ,
Number of rinses, see "Number of static rinses", page 146 ,
Duration of a rinse, see "Rinse time", page 189 .
Number of dynamic rinses, see "Dynamic rinses", page 93 ,
Location of dynamic rinses, see "Dyn. rinse", page 90 ,
Sequence end in Park, see "Sequence end in Park (Yes/No)", page
206 .
See also:
Edit a sequence with a sample changer:
Refer to "Programming sequence", page 159 .
Select a sequence with a sample changer:
Refer to "Select sequence", page 204 .
Run a sequence with sample changer:
Refer to "Running a SAC sequence", page 194 .