Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 146)

9–6 Creating Control List Selectors
Publication 2711-6.0
To set properties of a control list selector:
1. Double-click the control list selector object.
Opens
Tag Dialog
2. On the Properties tab, set the operating parameters of the Control
List Selector.
The following descriptions define properties of a control list selector.
Type
Specifies the type of control list: Standard or Piloted.
•
For a Standard list, control list items are selected by an operator.
•
For a Piloted list, control list items are selected by either the
operator or the logic controller writing to the search tag address.
Initial State
Specifies the control list selection on initial powerup of the terminal
and the initial value sent to the write tag address. The value of the
initial state overrides the initial value in the Tag Editor.
Setting Properties
of a Control List Selector