Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 462)

Validation Messages E–8
Publication 2711-6.0
Validation Message What to do Meaning
Unable to load (file) or one of its components PanelBuilder cannot open specified file. Verify that path contains AB\BIN\. Reboot
computer and try again.
Unknown graphic image An object or object state is assigned an inner
graphic that no longer exists. Select another inner graphic for the object or
import a bit map graphic with the same name.
Unused Block Transfer Channel will be
removed. A block transfer defined in the Block Transfer
dialog is not used by the application. Remove it from the application or reference it.
Unused Trigger This alarm trigger is not being used by any
alarms and will not be downloaded to the
terminal. Remove the trigger or use it in an alarm.
Used as indicator will display data written by a
control device using the same tag Warning that PanelView is using data from
write tag of control object to display data for
indicator. Nothing. Using the same write tag data for
the indicator eliminates ladder logic required
to move data from the write tag to read tag.
(Scale, Offset, Max, Min, or Initial) value of
(tag name) not valid or not in range A tag attribute isn’t configured properly. Open the Tag Editor from the Application
menu and change tag attributes as necessary.
Minimum array length of (tag) required for
object state data The bit array length of the tag is smaller than
required. Change values for the object’s states or
increase the bit array size in the Tag Editor.
Width (value) is out of range The width of the object is invalid. Resize the object.
Write tag not defined A write tag has not been defined for object. Open object’s dialog and assign a write tag.
Write and search tags must be different in
Piloted Control Lists. A Piloted Control List will not function if the
search tag and write tag are the same. Open the object’s dialog and change either
the write tag or search tag.