Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 473)

Troubleshooting F–11
Publication 2711-6.0
You must run and install the card driver (DTL_KT.EXE and
CFG_KT.EXE) before running the RNATSR and RNA.
RNA: ERROR –– no card drivers installed
RNA.EXE has already been run.
RNA: ERROR –– RNATSR <version> is already running
Your installation may have been unsuccessful. Re-install and restart
the INTERCHANGE Software. If this error still occurs, contact
your Rockwell Software Inc. Global Technical Support
Representative.
RNA: ERROR –– wrong version of KT driver
If either of these errors occur, call your Rockwell Software Inc.
Global Technical Support Representative.
RNA: Internal error. KTTSR_ATTACH returns <num1> instead of <num2>
RNA: Internal error – no driver has port <num>
These errors can occur if there was difficulty creating the packet
buffers or unsolicited table at startup. If that is the case, an error was
displayed at startup as well.
RNA: Error %X freeing the packet buffers
RNA: Error %
X freeing the unsolicited table
RNA: WARNING – no ports available on driver #x