Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 257)

16–3 Adding Graphics
Publication 2711-6.0
Use the Line command or Line tool to draw straight lines. As you
draw a line, you can drag it to any size or angle.
To draw a line:
1. Click the Line tool in the toolbox.
Or choose Line from the Objects " Graphics submenu.
2. Position the pointer (+) where you want to start the line.
3. Hold down the left mouse button and drag.
A line stretches from the starting point to the position of the
pointer, changing length and position as you move the mouse.
4. When the line is the right size, release the mouse button.
5. To draw another line, move the pointer to a new location and
repeat steps 3 and 4.
6. Click the right button to exit line mode.
Or click the selection tool on the toolbox.
Use foreground colors when applying color to lines.
Drawing a Line
"