Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 410)

23–22 Validating and Transferring Applications
Publication 2711-6.0
This section shows how to upload an application from a PanelView
terminal on a Remote I/O or DH-485 link to your computer on the
DH+ link.
Before uploading an application:
•
check cable connections.
•
enable Pass-Through in Block Transfer dialog (page 20–11).
•
configure DH+ driver using RSLinx or INTERCHANGE.
To upload an application from a terminal using Pass-Through:
➀ Choose Upload from the Application menu.
➁ Select the Upload parameters.
➃ When upload is complete, the application opens in PanelBuilder.
➂ PanelBuilder software and terminal display status of upload.
Enter name of .PVA file in which to
save uploaded application or click
Browse to search for a file.
Select Operator Terminal via Pass-Through
Select RSLinx or
INTERCHANGE Driver
Click OK to start
upload.
DH+ is active driver
Click Setup to configure Remote
I/O or DH-485 Pass-Through
parameters. See pages 23–14
and 23–15.
Select type of terminal from which you
are uploading application.
Under Presets, select values to upload:
S Original to upload presets (initial values)
defined for inputs.
S Current States to upload current input
values in terminal.
Uploading from a Terminal
Using Pass-Through