Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 381)

22–11 Multilingual Support
Publication 2711-6.0
This section shows the steps necessary to use a font file in a
PanelBuilder application.
The font file you want to use in PanelBuilder must be located in
\PBWIN\FONT. For details on how to create a font file see the first
section of this document.
Using font files requires:
•
PanelBuilder Software V2.3 (or later). Systems running earlier
versions of PanelBuilder, require an upgrade.
•
PanelView terminals running firmware V3.0 (or later). Terminals
with earlier firmware versions, will require a firmware upgrade.
To check the firmware running on your terminal, choose Terminal
Info from the Configuration Mode menu on the terminal.
Step 1 – Select a Terminal Supporting External Fonts
From the New Application or Terminal Setup dialog (Application
menu), select a PanelView terminal that supports external fonts.
Any terminal running firmware version 3.0 (or later) supports
external fonts.
This button is only
enabled for
PanelView terminals
running Firmware
Version 3.0 or later.
Creating an Application
using a Font File