Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 41)

2–17 Installation
Publication 2711-6.0
Other Software that Uses INTERCHANGE
To run other software (such as APS) that uses a different
INTERCHANGE driver on the same communication port as
PanelBuilder software, follow the steps below.
Note: If the software packages use the same INTERCHANGE driver
on a communication port (except for the DF1 driver), you can ignore
these steps.
1. Exit from Windows if necessary.
2. Type ABICSTOP at the DOS prompt, for example:
C:\> ABICSTOP
3. Run the other software.
Before running PanelBuilder software again, or other software that
uses different INTERCHANGE drivers:
1. Exit from Windows if necessary.
2. Type ABICRUN at the DOS prompt
Adding or Updating Communication Card
Update the CONFIG.SYS file when you add or modify a hardware
configuration for a communication card such as the KT or PCMK
card. Refer to the INTERCHANGE README and CFG_KT.TXT
files for details on how to do this. The memory manager you use
determines the type of, and syntax of, the (communications card)
entry required in CONFIG.SYS.