Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 352)

20–20 Terminal and Communication Setup
Publication 2711-6.0
The following table describes the options.
Use: To:
Order Specify the order of the month (M), day (D), and year (Y). The
initial default is MDY.
Separator Specify the character to separate the month, day and year. You
can enter any character as the separator. The default is the
slash (/).
Day/Month
Leading Zero Specify that the day or month appears as two digits. For
example, February 7 appears as 02–07. By default leading
zeros are not displayed, 2-7.
Year Specify the year as two digits or four digits. For example, the
year 1994 can display as 94 or 1994.
3. Set the options you want for the time format. The Sample area
displays the format as you select options.
The following table describes the options.
Use: To:
12-Hour Display the time in numbers representing hours between 0 and
11 (00:00 – 11:59).
The boxes to the right specify AM or PM, or other notations
such as CST, PST or EST.
24-Hour Display the time in numbers representing hours between 0 and
23. (00:00 - 23:59).
The box to right specifies a notation such as CST, PST or EST.
Separator Specify a character to separate the hours, minutes, and
seconds. The default separator is the colon (:).
Leading Zero Display the hours before ten as a two digit number with a
leading zero. For example, 3:15 would display as 03:15. By
default, the leading zero is not displayed.
Display
Seconds Display seconds. The default is to display seconds.
4. Click OK to save the settings and exit the dialog.