Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 355)

20–23 Terminal and Communication Setup
Publication 2711-6.0
The Display Maintenance Setup dialog allows you to set a daily
schedule for:
•
conditioning the display of a PanelView 900 monochrome
terminal to prevent image burn in.
•
degaussing (or demagnetizing) the display of a PanelView 1400.
Default maintenance for these terminals occurs at 12:00 am every
day. The maintenance will not start until the terminal is inactive.
Conditioning of the PV900 takes approximately 30 minutes;
degaussing of the PV1400 takes a few seconds.
The display maintenance schedule is downloaded with the
application if the “Use downloaded configuration settings” option is
enabled on the Power-Up tab of the Terminal Setup dialog.
To set a daily schedule for display maintenance:
1. Click the Maintenance button from the Advanced tab of the
Terminal Setup dialog.
This button is only available for PV900 monochrome and
PV1400 color terminals.
2. Select the Enable Display Maintenance check box to
enable/disable display maintenance. The default is enabled.
3. From the Hour list box, select the hour (0 – 23) at which to start
the display maintenance. The hour is defined in 24-hour military
time. The default is 0 or 12:00 am.
4. From the Minute list box, select the minute (0 – 59) of the hour at
which to start the display maintenance.
5. Click OK to exit and return to the Advanced tab.
Setting a Display
Maintenance Schedule