Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 459)

Validation Messages E–5
Publication 2711-6.0
Validation Message What to do Meaning
Object not on touch cell boundary A touch object doesn’t align with touch cells.
This can occur if the user assigns touch cell
input after the object has been sized. Resize object or move object until it snaps to
grid.
Object requires function key or touch
assignment The specified object isn’t assigned a function
key or touch cell for operator input. Open the object’s dialog and assign a
function key and/or touch cell.
Object too small to display text. The height of the object is too small to display
the first line of text. Increase the height of the object.
Overlapping control objects Two objects are overlapping on the screen. Access the screen and reposition or resize
the objects so they don’t overlap.
PLC or Scanner not configured in Terminal
Setup – Comms. Setup The PLC/Scanner with which the terminal will
communicate is not configured in Terminal
Setup (Communication Setup dialog). From the Setup tab in Terminal Setup, press
the Comms. Setup button to configure the
PLC/Scanner type and name.
PLC or Scanner not found in Project
Database The PLC/Scanner with which the terminal will
communicate is not defined in Terminal Setup
(Communication Setup dialog). From the Setup tab in Terminal Setup, press
the Comms. Setup button to define the
PLC/Scanner type and name.
Print Only Objects do not support printing of
double-byte characters. Double-byte font selected for print only object. Select a single byte size font.
Project database has not been defined for the
application The application is not linked to a tag
database. Open the Project Management dialog
(Application menu) and either create a project
or link an existing project to the application.
Read tag not defined A read tag has not been defined for the
object. Open the object’s dialog and assign a read
tag.
Rack number of the Terminal is not supported
by the Logic Controller The rack number assigned to the Remote I/O
PanelView terminal exceeds the rack number
supported by the controller or is set at 0 which
is not supported by the controller. From the Setup tab in the Terminal Setup
dialog, press the Comms. Setup button and
reconfigure the rack number.
Required Tag fields missing or incomplete. Tag has no type, node name, or address
specified. Complete tag information in the Tag Editor.
Remote Ack tag range must be greater than
or equal to trigger range. A bit array size for the Remote Acknowledge
tag was specified that is less than the
Trigger’s bit array. Make sure the bit array size for the Remote
Ack tag is greater than or equal to the bit
array for the trigger.
Saved device data is missing or corrupted
and cannot be used to update the device
database. The device data did not pass the CRC check
and will not be used to update the project
database. Use Communication Setup to recreate
devices.
Saved tag data is missing or corrupted and
cannot be used to update the tag database. The tag data does not pass the CRC check
and will not be used to update the tag
database. Use the Tag Editor to recreate the tags.
(Scale factor) value of (value) has too many
significant digits. A scale factor was entered with more than 4
significant digits. Enter a valid scale factor.
Search and control tags are required for
Piloted Control Lists. Either a search tag and/or a control tag was
not defined for a pilot control list. Both are
required. Open the object’s dialog and enter the
missing search tag and/or control tag.
Slot Number of Address does not match other
tags A tag has a different slot number than other
tags in the application. An application can
only access tags from one slot of an SLC. Verify that all tags in the application use the
same SLC controller slot number.
Startup screen must be assigned to an
existing screen Startup screen assigned to a nonexistent
screen in the application. The screen may
have been deleted. Select the Power-up tab from Terminal Setup
dialog and reassign the startup screen.
State number (number) out of range An object has an invalid state number. Select the object, open the List Management
dialog and delete the invalid state(s).