Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 38)

2–14 Installation
Publication 2711-6.0
4. Click OK to exit the dialog.
5. Exit Windows and reboot the computer to load the driver and its
configuration.
Important: You must reboot your computer any time you
add or remove a driver or change configuration
parameters of a driver.
After rebooting the computer, messages display indicating that the
INTERCHANGE driver was successfully configured and loaded.
For example, the following messages appear for the DF1 driver.
CFG_DF1 (001A) Reading device configuration from
C:\RSI\IC\BIN\CFG_KT.INI.
CFG_DF1 (0000) TSR configured, no errors detected
Important: Errors that occur during a reboot indicate an incomplete
or incorrect configuration of the INTERCHANGE
drivers. Reconfigure the drivers.
Editing INTERCHANGE Driver Parameters
To edit the configuration parameters of an active driver:
1. Select the driver from the Configured Devices list.
2. Click the Edit Device button.
3. Edit configuration parameters in the driver’s dialog.
4. Click OK to close dialogs.
5. Reboot your computer to load the new configuration.
Removing INTERCHANGE Driver
To remove a current driver configuration:
1. Select the driver from the Configured Devices list.
2. Click the Remove Device button.
You are prompted to confirm the operation. If you click Yes, the
driver is removed from the Configured Devices list.
3. Click OK to close dialog.
4. Reboot your computer to unload the driver.