Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 28)

2–4 Installation
Publication 2711-6.0
Installation Procedure
If the installation procedure detects the same version of
PanelBuilder, AB Utilities, INTERCHANGE or RSLinx Lite
software, you are given the option of reinstalling these components.
If the installation detects a newer version of software than what you
are installing, you are given the option of downgrading.
If you try to install RSLinx in Windows 95, and INTERCHANGE is
installed, you are warned of the conflict. The same is true if you try
to install INTERCHANGE and RSLinx is already installed.
To install PanelBuilder in Windows 95 or Windows NT:
1. Insert PanelBuilder disk 1 in Drive A: or Drive B:.
2. Click the Start button, click Settings and then click the Control
Panel.
3. Double-click the Add/Remove Programs icon.
4. On the Install/Uninstall tab, click the Install button.
5. Follow the install instructions on the screen.
To install PanelBuilder in Windows 3.x:
1. Insert PanelBuilder disk 1 in Drive A: or Drive B:.
2. In Program Manager, choose Run from the File menu ( ALT+F, R ).
3. Type the location you’re installing from plus the word setup.
For example, type a:setup
4. Click OK and follow the install instructions on the screen.
PanelBuilder setup with INTERCHANGE
To successfully transfer applications using INTERCHANGE drivers,
you must install PanelBuilder with INTERCHANGE. You cannot
install PanelBuilder and INTERCHANGE as separate components.
1. Enter and verify registration information. The serial number is on
your registration card.
2. Select setup option. Typical or Custom will install PanelBuilder
with INTERCHANGE.
3. Select destination folder for files.
•
Default for PanelBuilder and AB Utility files is C:\AB.
•
Default for INTERCHANGE files is C:\RSI.