Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 339)

20–7 Terminal and Communication Setup
Publication 2711-6.0
This section shows how to define runtime parameters for a
PanelView terminal and a controller that will communicate using
DF1 full duplex communications over a point-to-point link or DF1
network.
You define parameters for these two devices:
•
DF1 PanelView Terminal
•
SLC, PLC or MicroLogix controller
DF1 Port
PLC 5 Controller
PanelView
SLC
or
DF1 Port
MicroLogix 1000
AIC+
1761–NET–AIC
PanelView
DF1 Port
DF1 Port
To configure DF1 communications:
1. Choose the Setup tab from the Terminal Setup dialog.
2. Verify the terminal name entered in the Terminal Name field.
3. Click the Comms. Setup button.
The Communication Setup dialog shows the current DF1 settings
for the PanelView terminal and controller. The first time you
open this dialog, default settings appear.
The terminal name was defined when the application was created.
MicroLogix 1000
SLC 5/03, 5/04, 5/05
PLC-5/10, 5/12, 5/15, 5/25 via bridge
PLC-5/11, 5/20, 5/26, 5/40, 5/46, 5/60, 5/80 via Channel 0 Port
PLC-5/20C, 5/40C, 5/60C, 5/80C via Channel 0 Port
PLC-5/20E, 5/40E, 5/80E via Channel 0 Port
Terminal Name
from Setup tab.
Must match Node
Name in Tag Editor.
Select only when using DF1
network communications.
Defining DF1
Communications
"