Rockwell Automation 2711-ND3 PanelBuilder v2.60 Software User Manual - Manual (Page 350)

20–18 Terminal and Communication Setup
Publication 2711-6.0
Note: Terminal presets for control objects are set in the object’s
dialog. These values override initial values entered in the Tag
Editor except for numeric entry objects. Initial values for
numeric entry objects are set in the Tag Editor.
5. Specify whether to display the Last user screen on restart or the
startup screen. The default is to display the last user screen.
To display the startup screen, clear the check box.
6. Under Memory Card, specify what action the terminal should
automatically take on a restart if a memory card is loaded in the
terminal. The memory card stores only one application.
Select: To:
Always Load from Card Always load the application on the memory card.
Never Load from Card Require the operator to load a specific
application from the memory card using the
Memory Card Transfers option in the
Configuration Mode menu.
Load from Card if Invalid
Application Detected Load the application on the memory card only if
the current application in the terminal is invalid.
If a memory card isn’t loaded or if the card contains more than
one file, the terminal restarts with the application that was
running before the restart.
From the terminal, you can also manually download a memory
card application to the terminal by selecting Memory Card from
the Configuration Screen and then the Restore From Card option.
7. Specify whether or not to Use downloaded configuration settings
on the first restart after a download. The default is to use the
configuration settings downloaded with the application.
To use the current settings in the terminal on a restart, click the
check box until the X disappears.
8. Click OK to save the settings and exit the dialog.