Staticmemory configuration 0-3 registers, Staticmemory configuration 0–3 registers – Digi NS9215 User Manual
Page 251
. . . . .
M E M O R Y C O N T R O L L E R
StaticMemory Configuration 0–3 registers
www.digiembedded.com
251
The Dynamic Memory RAS and CAS Delay 0–3 registers allow you to program the RAS
and CAS latencies for the relevant dynamic memory. It is recommended that these
registers be modified during system initialization, or when there are no current or
outstanding transactions. Wait until the memory controller is idle, then enter low-
power or disabled mode.
Note:
The values programmed into these registers must be consistent with the
values used to initialize the SDRAM memory device.
Register
Register bit
assignment
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S t a t i c M e m o r y C o n f i g u r a t i o n 0 – 3 r e g i s t e r s
Address: A070 0200 / 0220 / 0240 / 0260
The Static Memory Configuration 0–3 registers configure the static memory
configuration. It is recommended that these registers be modified during system
initialization, or when there are no current or outstanding transactions. Wait until
the memory controller is idle, then enter low-power or disabled mode.
13
12
11
10
9
8
7
6
5
4
3
2
1
0
15
14
31
29
28
27
26
25
24
23
22
21
20
19
18
17
16
30
Reserved
Reserved
CAS
Reserved
RAS
Bits
Access
Mnemonic
Description
D31:10
N/A
Reserved
N/A (do not modify)
D09:08
R/W
CAS
CAS latency
00
Reserved
01
One clock cycle, where the RAS to CAS latency (RAS) and
CAS latency (CAS) are defined in
clk_out
cycles
10
Two clock cycles
11
Three clock cycles (reset value on
reset_n
)
D07:02
N/A
Reserved
N/A (do not modify)
D01:00
R/W
RAS
RAS latency (active to read/write delay)
00
Reserved
01
One clock cycle, where the RAS to CAS latency (RAS) and
CAS latency (CAS) are defined in
clk_out
cycles
10
Two clock cycles
11
Three clock cycles (reset value on
reset_n
)