Digi NS9215 - Manual (Page 84)

W O R K I N G W I T H T H E C P U
System control processor (CP15) registers
84 Hardware Reference NS9215
Figure 1: CP15 MRC and MCR bit pattern
The mnemonics for these instructions are:
MCR{cond} p15,opcode_1,Rd,CRn,CRm,opcode_2
MRC{cond} p15,opcode_1,Rd,CRn,CRm,opcode_2
If you try to read from a write-only register or write to a read-only register, you will
have
UNPREDICTABLE results. In all instructions that access CP15:
The opcode_1 field SHOULD BE ZERO , except when the values specified are used
to select the operations you want. Using other values results in unpredictable
behavior.
The opcode_2 and CRm fields SHOULD BE ZERO , except when the values specified
are used to select the behavior you want. Using other values results in
unpredictable behavior.
Terms and
abbreviations
This table lists the terms and abbreviations used in the CP15 registers and
explanations.
Cond 1 1 1 0 1 1 1 1 1 L
Opcode
_1
Opcode
_2
CRn CRm Rd
31 28 27 26 25 24 23 21 20 19 16 15 12 11 10 9 8 7 5 4 3 0
Term Abbreviation Description
UNPREDICTABLE UNP For reads:
The data returned when reading from this location is
unpredictable, and can have any value.
For writes:
Writing to this location causes unpredictable
behavior, or an unpredictable change in device
configuration.
UNDEFINED UND An instruction that accesses CP15 in the manner
indicated takes the
UNDEFINED instruction
exception.
SHOULD BE ZERO SBZ When writing to this field, all bits of the field
SHOULD BE ZERO .
SHOULD BE ONE SBO When writing to this location, all bits in this field
SHOULD BE ONE .
SHOULD BE ZERO or
PRESERVED SBZP When writing to this location, all bits of this field
SHOULD BE ZERO or PRESERVED by writing the
same value that has been read previously from the
same field.