Yaskawa MotionWorks+ Windows Software - Manual (Page 85)

MotionWorks+™ Electronic Cam Tool
79
Parameter Setting
This window defines the cam profile data. The cam profile can be divided into a
maximum of 20 sections. Note: Closing this window without pressing the OK button
discards all changes.
The table below details the items in the Set Parameter window.
Item Name Description
1 Number Cam data is displayed in sections. Up to 20 sections can be defined.
2 Phase Start The phase start value of each block is indicated.
This column is read only. The values are determined by data entered in
the Phase End Point column.
3 Phase End Set the phase end value of each section of the cam master.
4 Position Start Point The position start value of each section is indicated.
This column is read only. The values are determined by data entered in
the Position End Point column.
5 Position End Point Set the Position End Point value of each section of the slave.
1 3 4 5 6 7 8 2