Yaskawa AC Drive Z1000 - Manual (Page 99)

u Switches and Jumpers on the Control Board
The control board is equipped with several switches used to adapt the drive I/Os to the external control signals. Figure 3.47
shows the location of these switches. Refer to Control I/O Connections on page 100 for setting instructions.
V
I
A1 A2
Jumper S1
Terminal A1/A2
Voltage/Current Selection
OFF ON
DIP Switch S2
RS-422/RS-485
Termination Resistor
V
I
FM AM
Jumper S5
Terminal FM/AM
Voltage/Current Selection
Figure 3.47 Locations of Jumpers and Switches on the Control Board
3.9 Control Circuit Wiring
YASKAWA ELECTRIC TOEP C710616 45E YASKAWA AC Drive – Z1000 User Manual 99
3
Electrical Installation