Allied Telesis AT-S63 - Manual (Page 107)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 107
The Port Configuration menu is shown in Figure 27.
Figure 27. Port Configuration (Port) Menu
Note
If you are configuring multiple ports and the ports have different
settings, the Port Configuration menu displays the settings of the
lowest numbered port. After you have configured the settings the
port, all of its settings are copied to the other selected ports.
4. Adjust the following parameters as necessary.
Note
A change to a parameter is immediately activated on the port.
0 - Description
You use this option to assign a description to a port, from 1 to 15
alphanumeric characters. Spaces are allowed, but you should not
use special characters, such as asterisks or exclamation points.
(You cannot set a port description if you are configuring more
than one port.)
1 - Status
You use this option to enable or disable a port. When disabled, a
port does not forward frames to or from the node connected to
the port.
You might want to disable a port and prevent packets from being
forwarded if a problem occurs with the node or cable connected
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Port Configuration
Configuring Port 11
0 - Description ........................ Port_11
1 - Status ............................. Enabled
2 - HOL Blocking Prevention Threshold .. 8191 cells
3 - Flow Control
4 - Filtering
5 - Rate Limiting
6 - Negotiation ........................ Auto
X - Reset Port
F - Force Renegotiation
D - Set Port Configuration to Defaults
R - Return to Previous Menu
Enter your selection?