Allied Telesis AT-S63 - Manual (Page 532)

Chapter 24: Access Control Lists
532 Section IV: Security
Creating the Management ACL
To create a management ACL, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 7 to select Management
ACL.
The Management ACL menu is shown in Figure 171.
Figure 171. Management ACL Menu
Note
If you are managing the switch through a Telnet management
session, do not enable this feature until after you have entered the
ACE(s). Doing otherwise ends your management session.
3. From the Management ACL menu, type 2 to select Add Management
ACL Entry.
The following prompt is displayed:
Enter the IP address:
4. Enter the IP address of a specific management station (for example,
149.11.11.11) or a subnet (for example, 149.11.11.0). You must enter
an IP address.
The following prompt is displayed:
Enter the Mask:
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Management ACL Menu
Configuring Management ACL
1 - Management ACL Status ........... Disabled
2 - Add Management ACL Entry
3 - Delete Management ACL Entry
4 - Display All Management ACL Entries
R - Return to Previous Menu
Enter your selection?