Allied Telesis AT-S63 - Manual (Page 630)

Chapter 29: 802.1x Port-based Network Access Control
630 Section IV: Security
The Configure Port Access Role menu is shown in Figure 198.
Figure 198. Configure Port Access Role Menu
5. Type 1 to select Port Role.
The following prompt is displayed:
Enter new Port Role [N-None, A-Authenticator,
S-Supplicant] ->
6. If you type N for None, the port does not participate in port access
control. This is the default setting. If the port is connected to a
supplicant, type A to set the port’s role to Authenticator. If the port is
connected to an authenticator, type S to set the port’s roles to
Supplicant.
7. Repeat this procedure starting with Step 3 to configure the role of the
other ports on the switch.
After you have set port roles, go to ”Enabling or Disabling 802.1x
Port-based Network Access Control” on page 631 and activate the
feature.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Configure Port Access Role
Configuring Port 3
1 - Port Role ......... None
R - Return to Previous Menu
Enter your selection?