Allied Telesis AT-S63 - Manual (Page 327)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 327
Configuring SNMPv3 Entities
This section describes how to configure SNMPv3 entities using the
SNMPv3 Tables. To successfully configure this protocol, you must
perform the procedures in the order given. For overview information
about SNMPv3, see the ”SNMPv3 Overview” on page 318.
The following SNMPv3 tables are described:
❑ ”Configuring the SNMPv3 User Table” on page 328
❑ ”Configuring the SNMPv3 View Table” on page 338
❑ ”Configuring the SNMPv3 Access Table” on page 347
❑ ”Configuring the SNMPv3 SecurityToGroup Table” on page 363
❑ ”Configuring the SNMPv3 Notify Table” on page 371
❑ ”Configuring the SNMPv3 Target Address Table” on page 379
❑ ”Configuring the SNMPv3 Target Parameters Table” on page 392
❑ ”Configuring the SNMPv3 Community Table” on page 406
The SNMPv3 User, View, Access, and SecurityToGroup tables are
concerned with setting up a user, determining authentication and
privacy, and associating a user to a security group. The SNMPv3 Notify,
Target Address, and Target Parameters tables are concerned with
message notification. You use the SNMPv3 Community Table to
configure SNMPv1 and SNMPv2 communities.
Due to the complexity of the SNMPv3 configuration, Allied Telesyn
recommends that you configure the SNMPv3 protocol with the
procedures listed above, in the order they are listed. However, you can
configure the SNMPv3 protocol using the above procedures in any
order.