Resetting stp to the default settings – Allied Telesis AT-S63 User Manual
Page 266
Chapter 16: STP and RSTP
266
Section II: Advanced Features
Cost
Port cost of the port. The default is Auto-Update.
Priority
The number used as a tie breaker when two or more ports have
equal costs to the root bridge.
Resetting STP to
the Default
Settings
To reset STP to the default settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 78 on
page 259.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The STP menu is shown in Figure 79 on page 261.
3. From the STP menu, type D to select Reset STP to Defaults.
The following prompt is displayed:
Do you want to reset STP configuration to default
[Yes/No] ->
4. Enter Y for Yes or N for No and press Return.
The STP configuration is reset to the defaults.