Allied Telesis AT-S63 - Manual (Page 649)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 649
Note
Before enabling server-based authentication on the switch, you
should first configure the TACACS+ or RADIUS settings. If you
selected TACACS+, go to ”Configuring TACACS+” on page 650. If
you selected RADIUS, go to ”Configuring RADIUS” on page 654.
Disabling
TACACS+ or
RADIUS
To disable the authentication feature on the switch, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 6 to select
Authentication Configuration.
The Authentication Configuration menu is shown in Figure 205 on
page 648.
3. From the Authentication Configuration menu, type 1 to select Server-
based Authentication.
The following prompt is displayed:
Server Based User Authentication (E-Enabled,
D-Disabled) ->
4. Type D to disable the feature. The default is disabled.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.