Allied Telesis AT-S63 - Manual (Page 415)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 415
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Community Table Menu is shown in Figure
122 on page 412.
4. To change the Storage Type, type 4 to select Set Storage Type.
The following prompt is displayed:
Enter Community Index:
5. Enter the Community Index of the Storage Type you want to change.
The following prompt is displayed:
Enter Storage type [V-volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to an entry
in the SNMPv3 Community Table to the configuration file. After
making changes to an SNMP Community Table entry with a
Volatile storage type, the
S - Save Configuration Changes option does not appear on the
Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 Community Table to the configuration file. After
making changes to an SNMPv3 Community Table entry with a
NonVolatile storage type, the S - Save Configuration Changes
option appears on the Main Menu, allowing you to save your
changes. Allied Telesyn recommends this storage type.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.