Allied Telesis AT-S63 - Manual (Page 52)

Chapter 3: Basic Switch Parameters
52 Section I: Basic Features
The System Configuration menu is shown in Figure 5.
Figure 5. System Configuration Menu
3. Adjust the following parameters as necessary.
Note
A change to any parameter in this menu, including the IP address,
subnet mask, and gateway address, is activated immediately on the
switch.
1 - BOOTP/DHCP
This selection activates and deactivates the BOOTP and DHCP
client software on the switch. For information on this selection,
refer to ”Activating the BOOTP and DHCP Client Software” on
page 54.
2 - IP Address
This parameter specifies the IP address of the switch. You must
specify an IP address if you want the switch to function as the
Master switch of an enhanced stack. The IP address must be
entered in the format: xxx.xxx.xxx.xxx. The default value is 0.0.0.0.
3 - Subnet Mask
This parameter specifies the subnet mask for the switch. You must
specify a subnet mask if you assigned an IP address to the switch.
The subnet mask must be entered in the format: xxx.xxx.xxx.xxx.
The default value is 0.0..0.0.
4 - Default Gateway
This parameter specifies the default router’s IP address. This
address is required if you intend to remotely manage the switch
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
System Configuration
1 - BOOTP/DHCP ............. Disabled
2 - IP Address ............. 0.0.0.0
3 - Subnet Mask ............ 0.0.0.0
4 - Default Gateway ........ 0.0.0.0
5 - System Name ............
6 - Location ...............
7 - Administrator ..........
8 - Configure System Time
9 - Configure System Hardware
R - Return to Previous Menu
Enter your selection?