Allied Telesis AT-S63 - Manual (Page 71)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 71
Returning the AT-S63 Management Software to the Factory
Default Values
The procedure in this section returns all AT-S63 management software
parameters to the default values. Please note the following before you
perform this procedure:
❑ Returning all parameter settings to their default values also
deletes any port-based or tagged VLANs you created on the
switch.
❑ This procedure does not delete files from the AT-S63 file system.
To delete files, refer to Chapter 10, ”File System” on page 169.
❑ This procedure does not delete any encryption keys stored in the
key database. To delete encryption keys, refer to ”Deleting an
Encryption Key” on page 563.
❑ Returning a switch to its default values does not alter the contents
of the active boot configuration file. To reset the file back to the
default settings, you must reestablish your management session
after the swtich reboots and then select Save Configuration
changes. Otherwise the switch reverts back to the previous
configuration the next time you reset the switch.
Note
The AT-S63 management software default values are listed in
Appendix A, ”AT-S63 Default Settings” on page 669.
To return the AT-S63 management software to the default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 58.
3. From the System Utilities menu, type 4 to select Reset to Factory
Defaults.
The following prompt is displayed:
Do you want to reset to factory defaults? [Yes/No] ->
4. Type Y for yes or N to cancel the procedure.