Allied Telesis AT-S63 - Manual (Page 631)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 631
Enabling or Disabling 802.1x Port-based Network Access
Control
This procedure explains how to enable and disable port-based access
control on the switch. If you have not assigned port roles and configured
the parameter settings, you should skip this procedure and go first to
”Setting Port Roles” on page 629.
To enable or disable 802.1x Port-based Network Access Control, perform
the following procedure:
1. From the Main Menu, type 8 to select Security Configuration.
The Security Configuration menu is shown in Figure 175 on page
559.
2. From the Security Configuration menu, type 1 to select Port Access
Control (802.1X).
The Port Access Control (802.1X) menu is shown in Figure 197 on
page 629.
3. From the Port Access Control menu, type 1 to select Port Access
Control.
The following prompt is displayed:
Port Access Control (E-Enable, D-Disable):
4. Type E to enable port access control, or D to disable port access
control.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.