Displaying port status – Allied Telesis AT-S63 User Manual
Page 127
AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features
127
Displaying Port Status
To display the current status of the ports on the switch, perform the
following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 26 on page 106.
2. From the Port Configuration menu, type 2 to select Port Status.
An example of the Port Status menu is shown in Figure 34.
Figure 34. Port Status Menu
Note
The speed, duplex mode, and flow control settings are blank for a
port that has not established a link with its end node.
The Port Status menu displays a table that contains the following
columns of information:
Port
The port number.
Link
The status of the link between the port and the end node
connected to the port. The possible settings are:
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager
11:20:02 02-Oct-2004
Port Status
Port
Link
Neg
MDIO
Speed Duplex PVID
PortType
----------------------------------------------------------------
17
Up
Auto
MDI
10
Half
0001
10/100/1000Base-T
18
Up
Auto
MDI
100
Full
0001
10/100/1000Base-T
19
Up
Auto
MDI
100
Full
0001
10/100/1000Base-T
20
Up
Auto
MDI
100
Full
0001
10/100/1000Base-T
21
Up
Auto
MDI
10
Half
0001
10/100/1000Base-T
22
Up
Auto
MDI
100
Full
0001
10/100/1000Base-T
23
Up
Auto
MDI
1000
Full
0001
1000Base-X
24
Up
Auto
MDI
1000
Half
0001
1000Base-X
P - Previous Page
U - Update Display
R - Return to Previous Menu
Enter your selection?