Allied Telesis AT-S63 - Manual (Page 194)

Chapter 11: File Downloads and Uploads
194 Section I: Basic Features
Downloading an AT-S63 Configuration File Switch to Switch
This procedure explains how to download the active boot configuration
file on the master AT-9400 Series switch to another AT-9400 Series
switch in an enhanced stack. For an explanation of the boot
configuration file, refer to ”Working with Boot Configuration Files” on
page 172.
Note
You can perform this procedure from a local or Telnet management
session.
To download the active boot configuration file on the master switch to
another switch in an enhanced stack, perform the following procedure:
1. From the Main Menu, type 9 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 22 on page 99.
2. From the Enhanced Stacking menu, type 2 to select Stacking Services.
Note
The “2 - Stacking Services” selection is available only on master
switches.
The Stacking Services menu is shown in Figure 23 on page 100.
3. From the Stacking Services menu, type 1 to select Get/Refresh List of
Switches. The master switch polls the network for all enhanced
stacking switches in the subnet and displays the switches in the
Stacking Services menu.
4. Type 5 to select Download Configuration.
The following prompt is displayed:
Enter the configuration file name ->
5. Enter a name for the configuration file. This is the name under which
the file will be stored on the other switch. The name can be from one
to sixteen characters and must include the suffix “.cfg”.
After you have entered a name, the following prompt is displayed:
Enter the list of switches ->
6. Enter the number (Num column in the menu) of the AT-9400 Series
switch to which you want to download the configuration file. You can
specify more than one switch at a time (for example, 2,4,5).