Allied Telesis AT-S63 - Manual (Page 382)

Chapter 18: SNMPv3
382 Section II: Advanced Features
Target Parameters Name parameter in the Configure SNMPv3
Target Parameters Table.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
11. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 Target Address Table to the configuration
file. After making changes to an SNMPv3 Target Address Table
entry with a Volatile storage type, the S - Save Configuration
Changes option does not appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 Target Address Table to the configuration file. After
making changes to an SNMPv3 Target Address entry with a
NonVolatile storage type, the S - Save Configuration Changes
option appears on the Main Menu, allowing you to save your
changes. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 Target Address Table entry will take effect
immediately.
12. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Target
Address Table
Entry
You may want to delete an entry from the SNMPv3 Target Address Table.
After you delete an SNMPv3 Target Address Table entry, there is no way
to undelete, or recover, the entry.
To delete an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.